Step 7: Permit to install user applicationsĪs a security feature, the device or emulator you have connected to does not contain the necessary certificates for installing user applications, and you must install them before being able to run your application on it. You are now all set to deploy your app from Tizen Studio to the wearable device. The watch receives an RSA authentication request through a pop-up during this connection setup and it is mandatory to accept the RSA authentication to complete the process.įigure 7: Connecting to the watch from the Remote Device Manager To connect to the device, click on the Connect toggle next to the watch IP address and port information. You can also add a device manually from the Remote Device Manager window.įigure 6: Searching for available devices for connection The window shows a list of available devices and their IP addresses. In Tizen Studio, go to Launch Remote Device Manager.įigure 5: Launching the Remote Device Manager If you do not, the connection setup shows an error.įigure 4: Rebooting the watch Step 6: Establish the connection from the Remote Device Manager ěy using Wi-Fi under the same router Step 5: Restart the watchĪfter the previous steps have been completed, restart the device.After debugging, it should be set back to Auto again for better battery life.Ĭonnect the watch to the same network as your PC.Ĭhoose either of the following ways to connect the devices to the same network: Path: Settings > Connections > Wi-Fi > Always onĬaution: Setting the Wi-Fi to Always on can drain the battery drastically. Leaving the setting on Auto can sometimes create issues. This step is optional, but to avoid any unnecessary issues, it is better to set the Wi-Fi to Always on. Path: Settings > About Watch > Debugging is turned onįigure 2: Enabling debugging mode Step 3: Set the Wi-Fi to Always on You can enable debugging mode from the Settings menu, as shown below. In upgraded watches, you don’t need to disable Bluetooth.įigure 1: Disabling Bluetooth Step 2: Enable debugging mode If the watch has not been upgraded and the Tizen version is below 5.0, Bluetooth should be disabled during this process. Prerequisites: Tizen Studio 2.0 or higher Launch a project with Remote Device Manager Step 1: Disable Bluetooth You can also use the interface of the Remote Device Manager for executing SDB shell commands. Once the connection is made, a device log is shown in the Log View. Tizen-enabled devices can be connected or disconnected through the Remote Device Manager if they are on the same network. The Remote Device Manager provides a mechanism to deploy a project remotely from Tizen Studio to a Tizen-enabled device, such as Galaxy Watch.
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |